top of page

Spiral Elevator, Bucket Elevator or Inclined Conveyor? Choosing a Way to Lift Bulk Material

1 day ago
2 min read

When material needs to move from one level to another, there are three common options: a vibratory spiral elevator, a bucket elevator or an inclined conveyor. Each can do the job in the right application. The best choice depends on the product, the capacity, the height of the lift and the space available.

Illustration of a vibratory spiral elevator, a bucket elevator and an inclined belt conveyor side by side

Vibratory spiral elevators

A spiral elevator moves material up a helical trough wrapped around a central column. Two vibration motors drive the whole structure, and the product travels up the spiral in a series of small, controlled hops.

Strengths:

  • A small footprint. The lift happens within the diameter of the spiral, which makes good use of height. Our article on making better use of factory space explains why.

  • Gentle handling. There are no buckets, belts or chains in contact with the product, which suits fragile and free-flowing materials.

  • Simple cleaning. An open trough with few internal parts is easier to inspect and clean.

  • Processing on the way up. The long travel path can be used to cool, dry or condition the product, as in a cooling spiral elevator.

Limitations: very sticky, wet or cohesive products may not convey well under vibration, and capacity is limited compared with large bucket elevators.

Bucket elevators

A bucket elevator carries material in buckets fixed to a vertical belt or chain inside a casing. It is a well-established way to lift large volumes of grain, minerals and similar materials through considerable heights.

Strengths: high capacity, tall lifts and a compact footprint for the height achieved.

Limitations: the product is scooped and discharged at speed, which can cause damage or dust with fragile products. There are more wearing parts, such as belts, chains, buckets and bearings, and the enclosed casing can be harder to clean thoroughly between product changes.

Inclined conveyors

An inclined belt conveyor carries material up a slope. It is simple, familiar and suits a wide range of products.

Strengths: straightforward design, easy loading and discharge, and a continuous view of the product.

Limitations: the slope limits how steeply it can climb before material slides back, so a significant lift needs a long conveyor and a lot of floor space. Cleated or sidewall belts allow steeper angles but are more complex to clean. Belts also wear and need tracking and tensioning.

How to choose

Start with the product and the duty, then look at the space. These questions usually point towards the right option:

  1. How fragile is the product? Delicate products favour a spiral elevator.

  2. What capacity and lift height do you need? Very high tonnages over tall lifts often favour a bucket elevator.

  3. How much floor space is there? Where space is tight, a spiral or bucket elevator saves floor area compared with an inclined conveyor.

  4. How often will you clean or change product? Frequent changeovers favour open, accessible designs.

  5. Would cooling, drying or conditioning help? A spiral elevator can combine conveying with processing.

Talk to us about your application

We design and manufacture spiral elevators in Wisbech, Cambridgeshire. If you are weighing up the options, use our spiral elevator cost calculator for an initial budget figure, or send us details of your product, capacity and available space. Call Geraldo on 0800 001 6520 or email sales@spiralelevator.com.

Comments


bottom of page