top of page

Foot-Mounted or Flange-Mounted Vibrator Motor? How to Tell Which You Need

Nov 13
3 min read

Two vibrator motors can have the same centrifugal force and the same speed, yet bolt onto a machine in completely different ways. Before comparing ratings, it helps to know which mounting style you are dealing with. Most industrial vibrator motors are either foot-mounted or flange-mounted, and each has its own set of dimensions to check.

Illustration comparing a foot-mounted vibrator motor and its bolt pattern with a flange-mounted vibrator motor on a circular bolt circle

Foot-mounted vibrator motors

A foot-mounted motor sits on a cast or fabricated base with a row of bolt holes along each side. The base is bolted to a rigid mounting plate on the feeder, screen, hopper or compaction table. This is the most common arrangement and you will find it across almost every brand.

The fixing pattern is described by a few measurements:

  • The spacing across the feet, from the centre of a hole on one side to the centre of the matching hole on the other.

  • The spacing along the shaft, between holes on the same side. Six and eight-hole feet have more than one pitch, so record each one.

  • The hole diameter, and whether the holes are round or slotted.

  • The number of holes, usually four, six or eight.

Always measure centre to centre. Measuring edge to edge, or from the outside of the feet, is a common reason a replacement arrives and does not line up.

Flange-mounted vibrator motors

A flange-mounted motor is fixed through a circular or square flange rather than a set of feet. The motor is often mounted vertically, for example underneath a circular vibrating sieve or separator, where the motor drives the whole sieve body.

For a flange motor, the key dimensions are:

  • The pitch circle diameter (PCD) of the fixing holes, measured through the centres of the holes.

  • The number of holes and their spacing. Most patterns are evenly spaced, but some are not.

  • The hole diameter.

  • The overall flange diameter and any spigot or locating register.

Some square flanges use four holes on a square pattern. In that case, record the centre-to-centre distance along each side of the square. The equivalent PCD is that distance multiplied by 1.414.

Why the mounting style matters for a replacement

A replacement motor needs to match more than the fixings. Force, speed, supply voltage, frequency and enclosure all matter, and our guide to replacing a vibration motor sets out the full list. But the mounting is what decides whether the motor can be fitted without modifying the machine.

Changing from one fixing pattern to another usually means an adaptor plate or new holes in the mounting structure. On vibrating equipment, the mounting area carries high cyclic loads. Any change needs to be designed and made properly, otherwise cracks can start around new holes or welds.

Where possible, it is simpler to choose a motor with the same footprint as the one you are replacing. Different manufacturers often share common foot patterns, so a like-for-like fit from another brand is frequently possible.

Use the Footprint Finder to compare brands

Our free Vibrator Footprint Finder lets you enter the hole pattern of your existing motor and see which motors from other brands share it. You can search foot-mounted, flange-mounted and conical patterns, set a tolerance for near matches and filter by force and number of poles.

The results are based on the manufacturers' published catalogue dimensions. Always confirm the final choice against the manufacturer's drawing before ordering.

Before you order

Gather these details and you will have most of what is needed to identify a suitable motor:

  1. A clear photograph of the nameplate. Our guide to reading a vibration motor nameplate explains what to look for.

  2. The mounting style and fixing dimensions, measured centre to centre.

  3. A photograph of the motor in position on the machine.

  4. The supply voltage and frequency on site.

Browse our flange mount motors or the full vibrator motor range. If you would like us to check a match, call Geraldo on 0800 001 6520 or email sales@spiralelevator.com.

Recent Posts

See All

Comments


bottom of page