How to Adjust the Eccentric Weights on a Vibrator Motor
Most industrial vibrator motors have an adjustable centrifugal force. The force comes from eccentric weights fixed to each end of the motor shaft, and changing their relative position changes the force the motor produces. Adjusting them is a routine job, but it needs to be done carefully and in line with the manufacturer's instructions.

How the eccentric weights work
At each end of the shaft there are usually two weights: one fixed and one adjustable. When the weights line up with each other, their effect adds together and the motor produces its maximum force. As the adjustable weight is turned away from the fixed weight, part of its effect cancels out and the force falls.
Most manufacturers mark a scale on the weights or the shaft. Depending on the brand, it may show a percentage of the maximum force, an angle, or a setting number. The motor's data sheet gives the force at each setting.
Centrifugal force depends on the eccentric mass, its distance from the shaft and the square of the rotational speed. That is why a four-pole motor produces less force than a two-pole motor with the same weights, and why the same weight setting gives more force at 60 Hz than at 50 Hz.
Before you start
Isolate the motor electrically and lock it off. The machine must be stationary and safe to work on.
Have the manufacturer's instructions for your motor model to hand, including the fixing torque for the weight bolts.
Record the current setting at both ends before changing anything, preferably with photographs.
Check you have the right gaskets or seals for the weight covers if they need replacing.
Adjusting the weights
Remove the weight covers at both ends of the motor.
Loosen the adjustable weight on one end and turn it to the new setting on the scale.
Tighten the fixing to the torque the manufacturer specifies.
Repeat at the other end, setting it to exactly the same position.
Refit both covers and their seals before the motor is run.
Both ends must always be set identically. If they differ, the force is uneven along the motor, which can make the machine rock or twist and adds load to the bearings.
On machines driven by two motors, such as many feeders, screens and spiral elevators, both motors normally need the same setting too. Where a design uses different settings, follow the equipment manufacturer's instructions.
After adjustment
Run the machine and check that it behaves as expected. Listen for unusual noise and watch for rocking or uneven product movement. Measure the motor current and compare it with the nameplate rating. Increasing the force increases the load on the motor and its bearings, so the current should stay within the rated value.
If you increased the force to solve a problem, such as material not flowing or a screen blinding, it is worth asking why the extra force was needed. Wear, loose fixings, damaged springs or a change in the product can all change how a machine performs. Our guide to warning signs on vibrating equipment covers the common causes.
When not to adjust
Do not set the weights above the maximum the manufacturer permits, and do not add extra weights that were not designed for the motor. If the machine needs more force than its motors can safely provide, the motors may be undersized for the duty.
If you are not sure what setting your machine needs, or you suspect the motor is no longer suitable, contact us. We stock replacement motors and spares, and can help you check the setting against the motor's data. Call Geraldo on 0800 001 6520 or email sales@spiralelevator.com.




Comments